UNCONTROLLED COPY
GAD-SL-008  Helper 1 Duties

Helper 1

 

1.     1.            Watch Tail End of Coil

 

2.               Tell Operator to Stop

 

3.               Cut Tail / Possibly Assist Helper 2 with Roll Up & Band

 

4.               Follow Coil Out of Machine

 

5.               Shear Coil & Dump Scrap

 

6.               Place Stick (Wood)

 

7.               Band / Tape Coil(s)

 

8.               Recoiler:     Raise Over Arm

 

9.               Raise Outboard

 

10.                        Rotate Gripper Bar to Side

 

11.                        ½ (Jointly with Operator): Writing Finished Good #s on Product

 

12.                        Collapse Gripper Bar

 

13.                        Engage Pusher Plate

 

14.                        ½ (Jointly with Operator):Lower Knives and Check Clearance

 

15.                        Run Steel through Knives

 

16.                        ½ (Jointly with Operator): Check Cut Widths

 

17.                        Log Widths

 

18.                        Run Cuts Down Line

 

19.                        Rotate Gripper Bar to Top

 

20.                        Lower Over Arm

21.         Jog Steel Into Gripper Bar

 

22.                        Close Gripper Bar

 

23.                        Rotate Recoiler a Few Turns

 

24.                        Build Overarm

 

25.                        Watch Steel for Defects

 

26.                        Measure OD on Recoiler if Coil Breaks in Half

27.                        When When SL-22 Slows Down at Backend, Got to Uncoiler (if at end of coil).

 

Revision History

Revision Date Revision Level Changes Made
09/29/09 0 Original Version