Helper 2

1.  1.            Prepare Next Coil to Run

2.               Pull Coils in Saddle Closer to Recoiler

3.               Get Tag Off Next Coil to Run & Take to Operator

4.               Roll Up Band

5.               Collapse Uncoiler

6.               ½ (Jointly with Set-Up Man): Remove Wood

7.               Push Off Tail of Coil

8.               Lower Buggy & Load Next Coil

9.               Measure & Align Coil

10.                        Lower Over Arm

11.                        Cut Band Off Loaded Coil

12.                        Spin Coil – Lap Facing Machine

13.                        Recoiler: Move Car Under Coil & Set to Coil

14.                        Lower Coil Car Over Arm

15.                        Move Car Clear of Recoiler

16.                        Change Tension Stand Arm

17.                        Change Over Arm

18.                        ½ (Jointly with Set-Up Man):  Dump or Tie Scrap

19.                        Align Steel with Separators

20.            Put Pads in Tension Stand

21.            Center Over Arm

22.            Build Tension Stand Arm

23.            Go to Uncoiler

Revision History